firmware: add some debug messages
This commit is contained in:
parent
39f1548dbd
commit
4904dfe464
@ -100,7 +100,7 @@ uint32_t scan_dir(char* path, FILINFO* fno_param, char mkdb, uint32_t this_dir_t
|
||||
if(next_subdir_tgt > dir_end) {
|
||||
dir_end = next_subdir_tgt;
|
||||
}
|
||||
// printf("path=%s depth=%d ptr=%lx entries=%d parent=%lx next subdir @%lx\n", path, depth, db_tgt, numentries, parent_tgt, next_subdir_tgt);
|
||||
DBG_FS printf("path=%s depth=%d ptr=%lx entries=%d parent=%lx next subdir @%lx\n", path, depth, db_tgt, numentries, parent_tgt, next_subdir_tgt);
|
||||
if(mkdb) {
|
||||
// printf("d=%d Saving %lx to Address %lx [end]\n", depth, 0L, next_subdir_tgt - 4);
|
||||
sram_writelong(0L, next_subdir_tgt - 4);
|
||||
@ -251,7 +251,7 @@ uint32_t scan_dir(char* path, FILINFO* fno_param, char mkdb, uint32_t this_dir_t
|
||||
}
|
||||
} else uart_putc(0x30+res);
|
||||
}
|
||||
// printf("db_tgt=%lx dir_end=%lx\n", db_tgt, dir_end);
|
||||
DBG_FS printf("db_tgt=%lx dir_end=%lx\n", db_tgt, dir_end);
|
||||
sram_writelong(db_tgt, SRAM_DB_ADDR+4);
|
||||
sram_writelong(dir_end, SRAM_DB_ADDR+8);
|
||||
sram_writeshort(num_files_total, SRAM_DB_ADDR+12);
|
||||
|
||||
@ -466,8 +466,8 @@ int send_command_fast(uint8_t* cmd, uint8_t* rsp, uint8_t* buf){
|
||||
while((BITBAND(SD_DAT0REG->FIOPIN, SD_DAT0PIN)) && --timeout) {
|
||||
wiggle_fast_neg1();
|
||||
}
|
||||
//printf("%ld\n", timeout);
|
||||
DBG_SD if(!timeout) printf("timed out!\n");
|
||||
// printf("%ld\n", timeout);
|
||||
if(!timeout) printf("timed out!\n");
|
||||
wiggle_fast_neg1(); /* eat the start bit */
|
||||
if(sd_offload) {
|
||||
if(sd_offload_partial) {
|
||||
|
||||
Loading…
x
Reference in New Issue
Block a user